Part available on Amazon: https://amzn.to/2q7HEON
The Motor Driven Power Steering, or MDPS, Coupler is a common failure for these vehicles. It causes a clunking noise while steering. It is a simple rubber coupler that gets shredded over time. This specific car had 75,000 miles on it when it failed. We’ll show you how to replace it.
MDPS Rubber Coupler: https://amzn.to/1IH2X1N
이제 한국어 자막을 사용하실 수 있습니다.
자막 버튼을 누르신 후 설정에서 원하시는 언어를 선택해주시기 바랍니다.
01:42 – Remove Covers
———– Remove Bolts Behind Steering Wheel, Re-Center Steering, and Then Disconnect Battery
02:20 – Remove Metal Shield
02:48 – Remove AC Duct
03:30 – Loosen Steering Column
———– See 23:27 For Back Bolts
04:20 – Disconnect Plugs and Mounts
———– Lower Steering Column
08:52 – Unbolt Computer from Motor
10:40 – Remove Bracket Plate
12:08 – Remove Computer from Motor
12:32 – Unbolt Motor
12:55 – (Optional) Disconnect Steering Shaft
13:55 – Remove Motor
15:01 – Remove Debris
17:04 – Install New Part
18:06 – Connect Motor
20:56 – Bolt Motor
21:27 – Install Computer
22:02 – Install Bracket Plate
23:55 – (Optional) Install Steering Shaft
———– (Optional) See 24:56 About Installation
24:31 – Bolt Steering Column Back Up
26:00 – Connect Plugs and Mounts
26:34 – Connect Battery, Start Engine, Verify Repair
27:18 – Install AC Duct, Metal Shield, and Covers
28:21 – Final Thoughts
Post time: Jul-30-2017